Innehåll som kan döljas
Description
Blistered sills are a common problem on the Tesla Model Y.
Our mudguards protect your Model Y from road salt, asphalt cracks and other dirt thrown up by the wheels. The mudguards blend well with the rest of the car and look like they came straight from the factory. A popular and sought-after accessory for your Tesla!
The matte black Model Y mudguards in a more powerful model are better suited for those places with really tough winters but are perfect for those who want to avoid stone chips on the thresholds! It's taller than our other model while the mounts are stronger to cope with larger ice and snow clumps that build up in the wheel arch. It's also more durable, which is great if you drive your car over high edges where the mudguards are likely to touch the ground.
A set includes:
4 mudguards (2 front right/left & 2 rear right/left).
The mudguards are in soft quality ABS plastic in a matte black look.
Protective film to place under the mudguards to protect the paint on the car.
Clips for mounting.
Installation
The installation usually takes about 10 minutes for each mudguard for someone who has never worked with cars before.
Protective film (not necessary on Model Y)
When you install the protective film, the paint around the wheel arches must of course be clean!
Identify how much protective film you need, the length of the protective film is enough to fit all four mudguards.
We usually recommend the following, cut the protective film into four equal parts. Each piece can then be divided widthwise, this means that the set of protective film included is enough for the entire first year. We recommend that you change the protective film 1-2 times a year if you are very careful about the paint under the mudguards, preferably every time you change your tires. You can find more protective film HERE.
Hold the mudguards up against the car to identify how far into the paint the edge of the mudguard goes. Here the ambition is to be as close to this edge as possible with the protective film as it is precisely the edge of the mudguards you want to cover with the protective film.
The protective film has a thin plastic film on both sides of the film. First peel off the plastic film covering the adhesive side. Install the film in the desired location and then peel off the plastic that protects the surface of the protective film.
Front splash guards:
Start by removing the two clips on the inside of the wheel arch, holding the mudguards up against the car and the wheel arch. Push in the new clips provided in the package.
Rear mudguards
For the rear mudguards, in addition to the clips inside the wheelhouse, there is also a 10 mm screw at the bottom behind the wheelhouse, this should be removed during installation. When the clips in the wheel housing and the screw underneath are removed, it is time to install the mudguard.
Hold the mudguards up against the car and the wheel housing. Push in the new clips included in the package, while the 10 mm screw at the back of the car under the car should be screwed in again, this time with the mudguard in place in line with the hole.
Inside the wheel housing there is also a small nut that holds the "arm" of the mudguard that goes into the wheel housing. Remove the nut that sits on the screw in the wheelhouse, press the mudguard and screw the nut back on.
If you want help with the installation, you must select the installation with the product above and the location for installation.
We will contact you to book a time for assembly, expect about 1-2 weeks for a booked time.
Installation time: 40 minutes.