Open the hood without power

In the unlikely event that Model 3 does not have low voltage power, you cannot open the front trunk using the touchscreen, remote key, or mobile app. In this case, open the front trunk as follows:

Note: The following steps to open the front trunk do not work if Model 3 is locked and the low voltage power supply is active.

• Locate an external low voltage power supply (as a jump start).
• To release the tow eye shield, press firmly on the upper right edge of the shield until it swings inward, then gently pull the raised portion toward you.

Anm: Depending on the date of production, either the positive or negative pole may be attached to the tow eye guard.

Note: (For vehicles manufactured from approximately January 2024) the vehicle may also have a tow eye guard near the rear bumper. It is only used for transportation and does not have the correct cables to start the battery. Use only the front tow eye cover.

• Pull the two wires out of the tow eye opening to expose both poles.
• Connect the red positive (+) wire of the low voltage power supply to the red positive (+) terminal.
• Connect the black negative (-) wire of the low voltage power supply to the black negative (-) terminal.

Note: Using an external low-voltage power supply on the poles only releases the hood locks. You cannot use the positive and negative terminals to charge the low voltage battery. Do not leave the low voltage power cables connected to the terminals for more than 30 seconds. Remove them from the vehicle terminals as soon as the hood latches.

• Turn on the external power supply (see manufacturer's instructions for details). The hood latches will immediately release, allowing you to open the hood and access the front trunk.
• Disconnect both cables, starting with the black negative (-) cable.
• If you are towing the vehicle on a flatbed transportation vehicle, do not put the cover back on the towing eye yet. If necessary, fit the tow eye guard by inserting the two wires into the opening of the tow eye and fit the tow eye guard in the correct position and snap it into place.