Replacement of the gas springs of the luggage compartment (non-powered)

Note: This procedure is intended for vehicles manufactured before approximately January 2024.

Note: Do not attempt to change the gas springs on power tailgates.

If the trunk gas springs do not work for any reason, they can be replaced. To replace the trunk gas springs:

1. Open the hood and use a temporary, non-threatening support to hold it open.
2. Use a pry tool to loosen the clip that attaches the lower end of the gas spring to the vehicle hinge and release the gas spring.
3. Use a pry tool to loosen the clip that secures the upper end of the gas spring to the hatch hinge and remove the gas spring from the vehicle.
4. Clean the attachment points and lubricate both attachment points of the new gas spring.
5. Attach the piston end of the gas spring to the vehicle hinge and the cylinder end to the hatch hinge. Ensure that the clips are fitted correctly.
6. Remove the temporary support and check that the boot lid opens and closes correctly.