Tesla Model Y Spoiler / Wing carbon fiber matte

Tesla Model Y spoiler made of real carbon fiber, matte finish.

Installed on a clean car, before installation, the surface should be wiped off. Then you place the wing in the center at the edge of the trunk lid, the wing should "hug" the edge then it is placed correctly.

On the trunk lid, you then mark the center, as well as the respective edge where the wing ends (preferably with masking tape) and also the center of the wing. Remove the cover for the mounting tape and place it in position.

Do not press the wing firmly but start by checking that it is within the markings, if the wing is slightly crooked it can be corrected as long as you have not pressed the wing firmly.

If you think the placement is good, just start pressing, start on both outer edges and work inwards in the center. Press for 3-4 minutes in total over the entire wing for a successful installation.

Please note that the assembly should be done on a hot car where the surface is at least 15 degrees.